If you have a pump, refer to the pump&39;s manual for instructions.

4).

. .

1) Unplug the Filter Pump.

.

Locate pumps and filters in such a way that children cannot climb on them to gain access to pool. Page 13 Connect the pump to the spa by Remove the two stopper caps from Screw the filter set to the inside of the lining up the letters (A to A, B to B the inside of the spas inlet and spas outlet pipe. Bestway Pool Filter Pump Installation DIY easy instructions for a good pool filter pump without the best installations instructions.

18&39; Coleman Power Steel Swim Vista.

. Top Rail for 18&39; Power Steel Swim Vista Series Above Ground Pools by Coleman. When you touch the filter, pump, or electrical parts, be sure the ground under your feet is Bone Dry.

Make sure that the ring fits snugly over the head of the plungers valves. Unplug and then plug the pump back in to start the system.

E- referrerpolicyorigin targetblankSee full list on manualslib.

Download.

Do not place portable appliances closer than 5 feet (1. Locate pumps and filters in such a way that children cannot climb on them to gain access to pool.

. Do Not Remove Ground Pin 2) Inspect Cord Before Using Do Not Use If Cord Is Damaged.

.
1in x 3.
.

1) Unplug the Filter Pump.

WARNING - RISK OF ELECTROCUTION 1) Connect Only To Properly Grounded Outlet.

When installing and using this equipment, basic safety precautions shall always be followed, including the following IMPORTANT SAFETY INSTRUCTIONS READ, FOLLOW, AND UNDERSTAND ALL INSTRUCTIONS AND. - WARNING The use of a swimming pool implies compliance with the safety instructions described in the operating and maintenance. to3Icr4aa.

. 2. WARNING The pump cannot be used while people are inside the pool - If you have a ladder, refer to the ladders manual for instructions. 3) Unscrew the Filter Cap Retainer and remove the Filter Cap. POOL SUCTION FITTING INSTRUCTIONS. IMPORTANT DO NOT DRY RUN THE FILTER PUMP Make sure both the pools Inlet and Outlet valves are fully covered by water before operating the Filter Pump.

.

1) Unplug the Filter Pump. 1) Unplug the Filter Pump.

.

.

Place the pool near an adequate drainage system to deal with overflow water and ensure the pools inlet A and outlet B are correctly positioned to allow your filter.

This is the suction, or intake, end of the pumpmotor assembly and usually leads to an enclosed basket.

.